1. .Run IDLR-12(V2) App (Ethernet) 3.3.exe
2. Click on connect to establish connection with the reader.
3. Click on Read Multi Tag button & present a card to the reader.
4. The Results are displayed in the EPC table as in the below picture.
5 To decode the card number select the 6th & 7th Byte from the 12 Bits Hexadecimal code & convert using windows calculator set to Programmer mode.
6 Next Proceed to configure the reader using IDLR-12(V2) Configuration utility.
7 Select Ethernet Radio button & click on connect to establish connection with the reader.
8 Click on the Reader tab & select Polling radio button under work mode.
9 Click on set & Click on the Reset Button to save the settings & Initialize the reader.
10 Wait for the rader to Reboot & present a tag to verify proper operation